Roll pass design for continuous bar mill

ROLL PASS DESIGN 
We should know following things before Roll pass design 
1:-   Autocad designing 
2:-   Number of passes required 
3:-   Section weight
4:-   Section Areas 
5:-   Draft And Maximum Draft 
6:-   Spread 
7:-   Redaction 
8:-   Elongation 
9:-   Angle of bite 
10:- Contact length 
11:- Coefficient of Friction 
12:- Forward slip 
13:- Backward slip
14:- Volume rates of deformation 
15:- Specific Roll pressure 
16:- mps /rpm
17:- Gear ratios 
18:- Power required 
19:- Torque

https://svinaykumar1987.blogspot.com/2021/08/roll-pass-design-for-continuous-bar-mill.html

 We will explain one by one topic 

Comments

Post a Comment

Popular posts from this blog

Roll pass design ( Number of passes required in Rolling)

Image
When we talk, how many passes required in rolling then we calculate Number of passes   Number of passes = log of coefficient of Elongation / log(1.29) Where  1:- Number of passes can be 6 , 9 , 15 , 19 , 21, 24, etc according Billet Size and Finished Size  2:- co-efficient of Elongation = Billet Area / Finished Size Area  https://svinaykumar1987.blogspot.com/2021/09/section-areas-in-rolling-mill.html 3:- log(1.29)= 0.1105897103 Example:- Billet Size- 150×150 mm                   Billet Area- 22500                   Finished Size- 20 mm                   Finished Area- 314  Co- efficient of Elongation = 22500 / 314                                                 =71.656051   ...
Read more

Section Areas in Rolling Mill

Image
Section Area 1:- Square Area = Side × Side  2:- Ovel Area     = a × b ×  3.1428571429 https://svinaykumar1987.blogspot.com/2021/09/roll-pass-design-number-of-passes.html 3:- Round Area =   3.1428571429 × r × r  https://svinaykumar1987.blogspot.com/2021/08/roll-pass-design-for-continuous-bar-mill.html 4:- Rectangular Area = L × W 
Read more